Velleman-projects K8029 Assembly instructions Manuel d'utilisateur télécharger pdf (Page 14)

Restore factory settings:

The standard factory settings for the delay times can be

restored by setting switch 1 & 2 of the DIP switch to

‘ON’ (*4). If the voltage is switched on to the kit in this

state then LD2 (yellow) will flash. After that keep the

pushbutton pressed in until both LD1 and LD2 flash. The

standard times of 3 minutes are now again stored in

memory. Switch the voltage off and select an operating

mode using DIP switch SW1 (slow ON/OFF or step

mode).

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

Velleman-projects K8029 Assembly instructions Manuel d'utilisateur Page 14